نوار فولادی گالوانیزه: عرض, راهنمای پوشش و کاربردها

نوار فولادی گالوانیزه: عرض, راهنمای پوشش و کاربردها

Galvanized steel strip is the quiet workhorse of the metal industry. Most buyers never see it — it is inside cable trays, strapping bands, furniture channels, hose clamps and light-gauge framing. But when you need it, the specification is easy to get wrong: عرض, thickness and coating class all interact, and a mistake means a coil that cannot run on your line. This guide covers how strip is made, what the key parameters mean, and how to order it correctly.

How Galvanized Strip Is Produced

Galvanized strip starts as a wide hot-dip galvanized coil, usually DX51D+Z, produced on a continuous galvanizing line. The wide coil is then slit into narrow widths on a slitting line — from 10 mm up to about 600 mm — and rewound into compact coils for delivery. Because the strip is coated before slitting, the process is fast and economical, and the coating is perfectly uniform across the original width. ما نوار فولادی گالوانیزه follows exactly this route, with the same DX51D+Z chemistry and Z-class options as full-width کویل گالوانیزه.

Reading a Strip Specification

A complete strip specification has four parts: width × thickness, coating class, وضعیت لبه, and coil weight. “50 × 1.2 میلی متر, Z120, slit edge, 3 t coils” means a 50 mm wide strip, 1.2 میلی متر ضخامت, with a Z120 zinc coating, square cut edges, delivered in coils of about 3 تن. The two edges to watch are the coating class (see our separate galvanized sheet guide on Z classes) and the edge condition — slit edges are standard, but edge trimming removes burrs when the strip feeds a stamping or roll-forming press.

Width and Thickness Limits

پارامترStandard rangeتوجه داشته باشید
عرض10 – 600 میلی مترSlit to exact width
ضخامت0.20 – 4.0 میلی مترThinner = tighter tolerance
پوششZ40 – Z275Indoor to coastal duty
Coil ID / OFشناسه 508 میلی متر / OD ≤ 1250 میلی مترFits standard uncoilers
وزن کویل≤ 12 tSplit on request

برنامه های کاربردی معمولی

Galvanized strip is consumed by five big industries. Cable tray and raceway makers roll strip into side rails and rungs; strapping producers slit it into banding for packing and bundling; roll-formers turn it into purlins, studs and light-gauge sections; the furniture industry draws it into desk and shelf channels; and fastener companies punch it into hose clamps, clips and ties. In all of these, the two properties that matter most are dimensional consistency — the line cannot tolerate width wandering — and coating adhesion, because tight bends and punches will expose the steel if the zinc does not hold.

 - اخبار تجارت - 1

Ordering Checklist

Before you send an inquiry, decide the five points: exact width and thickness in millimetres; coating class (Z120 is the most common export choice; Z275 for outdoor service); وضعیت لبه (slit vs trimmed); coil weight and inner diameter to match your uncoiler; and quantity in tonnes. If the strip will be painted or formed into tight bends, say so — we can supply skin-passed or zero-spangle surface for a smoother paint finish. For full-width flat products the same chemistry applies to galvanized sheet.

Every strip coil ships with a mill test certificate confirming chemistry, coating weight and dimensions, so your incoming inspection can verify the delivery in minutes.

Request a strip quote